admin@bomai-autoparts.com

+86 137 5447 8129

Cangzhou Bomai Automobile Accessories Co., Ltd. Cangzhou Bomai Automobile Accessories Co., Ltd.
News

Home >> News >> Causes of leaking tires

Causes of leaking tires

Released on May. 23, 2022

The air leakage of the tire valve may be due to the aging of the valve, which is mainly manifested as cracks, deformation or hardening on the surface. If the aging phenomenon occurs, the valve should be replaced in time; it may also be due to the poor sealing between the valve and the hub. , it is necessary to replace the valve or wheel hub according to the situation; there is another possibility that the valve core is damaged, and the valve core or valve assembly should be replaced according to the situation.


When the valve still leaks after replacing the valve, and the cause cannot be found, you can start from the situations listed below. Because there are very few reasons for tire leakage, it is nothing more than the valve, valve core, tread, and wheel hub. After eliminating the valve and valve core problems, there are only treads and hubs left.


1. Due to the bumpy road surface or the effect of cold shrinkage and thermal expansion, and the deformation of the wheel hub, there is a gap between the tire and the wheel hub, causing the tire to leak. You can sprinkle water on the connection between the tire and the hub, if there are air bubbles, the seal is not tight;


2. When the car encounters a sharp object during driving, it pierces into the tire. You can sprinkle water on the tire surface to check, if there are air bubbles, it means air leakage;


3. The tire may rub against the curb, causing the side of the tire to be scratched. This condition can be observed with the naked eye;


4. It may be that during the tire installation process, the inner edge of the tire is damaged due to incorrect operation, so that the inner edge of the tire does not fit tightly with the tire. If this happens, the tires can be removed for inspection.


If it is found that the tire valve is leaking, then you need to replace the new valve, cut off the old one, and re-install the new one. In the process of installing the new air nozzle, if you find that it cannot be plugged in, you can apply some detergent to lubricate it. The valve is an independent valve body device, which is mainly used to inflate and release the gas in the tire, and plays an important role in maintaining the tire pressure. The valve should also be replaced regularly to prevent it from aging and causing the tire to leak.